Table of Contents
Advertisement
Disassembly & Re-Assembly
In addition to easily folding and unfolding, the Rascal AutoGo can be quickly and easily disassembled for storage or
transport, then re-assembled when needed. Instructions to take your Rascal AutoGo apart and put it back together are
presented in this section.
Taking the Rascal AutoGo Apart
Taking the Rascal AutoGo apart involves removing the seat
and Battery Pack, flattening the seat frame, and removing
the drivetrain. Instructions to disassemble the Rascal
AutoGo appear in the following.
1. Turn power "OFF." Fold seat back down.
2. Pull seat latch bar on rear underside of seat. Lift rear of
seat, and slide seat forward to disengage from the frame
(see Illustration 12).
Rascal AutoGo Owner's Manual
EMC Part: 19286400 Rev.01 03/09/07
31
Illustration 12 — Seat Removal
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rascal AutoGo and is the answer not in the manual?
Questions and answers
is there a way to test my rascal autogo onboard battery charger?
To test the onboard battery charger of a Rascal AutoGo, follow these steps:
1. Check the Battery Pack LED – Ensure the LED on the Battery Pack is lit when plugged in.
2. Verify Cord Connections – Make sure the power cord is properly plugged into both the Battery Pack and the electrical outlet.
3. Observe Charging Behavior – If the battery does not charge, load test the batteries to determine if they need replacement.
4. Check for a Faulty Charger – If the Battery Pack LED is not lit and connections are correct, the charger may be defective. Contact Electric Mobility or an Authorized Service Center for further assistance.
This answer is automatically generated