Table of Contents
Advertisement
Curbs and Small Obstacles
ALWAYS climb or go down small obstacles slowly to avoid damage to
the vehicle.
DO NOT attempt to ride over curbs or any other obstructions
higher than 1 inch (2.54 cm).
Freewheel Operation
The Rascal AutoGo features a "freewheel" mode to allow it to be
pushed by hand (manual operation). To activate manually, turn the key
switch OFF and locate the brake release lever under the rear cover
on teh right side. Push lever down to disengage the brake release.
Move lever up to reengage the brake. When your vehicle is in manual
mode, brakes will not operate.
WARNING!
Never sit in vehicle if it is in "freewheel"
mode on an incline.
Rascal AutoGo Owner's Manual
EMC Part: 19286400 Rev.01 03/09/07
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rascal AutoGo and is the answer not in the manual?
Questions and answers
is there a way to test my rascal autogo onboard battery charger?
To test the onboard battery charger of a Rascal AutoGo, follow these steps:
1. Check the Battery Pack LED – Ensure the LED on the Battery Pack is lit when plugged in.
2. Verify Cord Connections – Make sure the power cord is properly plugged into both the Battery Pack and the electrical outlet.
3. Observe Charging Behavior – If the battery does not charge, load test the batteries to determine if they need replacement.
4. Check for a Faulty Charger – If the Battery Pack LED is not lit and connections are correct, the charger may be defective. Contact Electric Mobility or an Authorized Service Center for further assistance.
This answer is automatically generated