Transporting The Rascal Autogo - Rascal AutoGo Owner's Manual

Rascal AutoGo Owner's Manual

Transporting the Rascal AutoGo

By Car — To transport your disassembled Rascal AutoGo by car, place each of the components into the trunk, being
careful not to scratch or mark any of the finished surfaces. If you need assistance lifting weights, consider asking
Electric Mobility's Customer Service Department or your authorized service center about the Power Trunk Lift. This
device will assist you in transporting your Rascal AutoGo by transferring these components in and out of your trunk
with very little effort. (See "Specifications" for more information on weights).
By Airplane — To transport your Rascal AutoGo on an airplane, we recommend that you notify your airline of your
mobility vehicle at least 24 hours prior to departure through your travel agent or in person. Ask your airline or your
travel agent whether they will need to disassemble the Rascal AutoGo or whether they plan to load and store it on the
plane without disassembly. Ask specifically where and with whom you should drop the unit off and where and with
whom you should retrieve it at your destination.
Note: Your Rascal AutoGo is equipped with sealed lead acid batteries. These batteries are approved by the Federal
Aviation Authority (FAA) for air travel.
Remember to bring this manual with you as a reference on your trip. Your manual will assist you in disassembling and
re-assembling your Rascal AutoGo if required.
Prior to leaving the airport, remember to test the Rascal AutoGo when first getting on it. Direct any questions to the
airline personnel if the unit does not work as it did prior to transportation.
EMC Part: 19286400 Rev.01 03/09/07
36