Assembling Your Scooter Following Transportation - Rascal Vecta Sport Owners Manual & Service Record

Warning!
Do not attempt to lift any of the
scooter components unless you are capable
of doing so. The weight for each component is
shown in the Technical Specification (page 27).
Warning!
Do not attempt to lift the chassis
un-assisted - back or other injury may result!
Assembling your Scooter
following Transportation
Warning!
Assembling the scooter involves
lifting and handling heavy parts. Your scooter is
not designed for unassisted loading into and out
of a car or similar vehicle. Specialist ramps and
hoists are available for transferring the scooter
into and out of a vehicle. Your dealer should
advise you on the best way to assemble your
scooter.
Warning!
Pinching or Crushing. Be careful
to avoid being pinched or having your hands
crushed when lifting or handling parts. Wear
gloves whenever possible.
Warning!
Never unload your scooter on slop-
ing or uneven ground. It could run down the
slope and injure someone.
After removing your scooter from a vehicle and
placing it on level ground, check it is undamaged
before starting to assemble it as follows:
1. Push the tiller release lever downwards, as
shown and raise the tiller to your preferred driving
position. (Fig.19). Release the tiller lever when the
desired position is reached.
2. Grasp the seat on both sides and insert the
seat post into the seat-post tube in the chassis
(Fig.20).
3. Fold the seat-back into the vertical position
(Fig.21).
18
19
20
21
Finally check the scooter is not damaged and it is
properly assembled, checking that the battery indi-
cator shows the battery is charged, the freewheel
lever is in the drive position, the seat is locked in
place and the finger controls operate correctly. You
are now ready to drive the scooter away.
Rascal Vecta Sport Scooter Owner's Manual and Service Record