Table of Contents
Advertisement
Charging Batteries
The Rascal AutoGo is equipped with two maintenance-free, airline approved, sealed 12V/15A batteries with an integral
automatic battery charger mounted in a detachable Battery Pack installed onto the front of the tiller. Because your
batteries may only have a partial charge when you first receive your vehicle, you may not experience full riding time until
you have fully charged them. Charging your batteries as specified in the following instructions will ensure maximum life,
power, and range.
It is recommended to charge your batteries:
• Upon initial receipt of your Rascal AutoGo
• For 6-8 hours (overnight) after extended use during the day
• Whenever the fuel gauge indicator goes into the red area (see page 17)
• The battery's life expectancy may be shortened if batteries are left fully discharged for more than a day
Battery Pack and power cord connections are shown in Illustration 2.
Rascal AutoGo Owner's Manual
EMC Part: 19286400 Rev.01 03/09/07
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rascal AutoGo and is the answer not in the manual?
Questions and answers
is there a way to test my rascal autogo onboard battery charger?
To test the onboard battery charger of a Rascal AutoGo, follow these steps:
1. Check the Battery Pack LED – Ensure the LED on the Battery Pack is lit when plugged in.
2. Verify Cord Connections – Make sure the power cord is properly plugged into both the Battery Pack and the electrical outlet.
3. Observe Charging Behavior – If the battery does not charge, load test the batteries to determine if they need replacement.
4. Check for a Faulty Charger – If the Battery Pack LED is not lit and connections are correct, the charger may be defective. Contact Electric Mobility or an Authorized Service Center for further assistance.
This answer is automatically generated