Table of Contents
Advertisement
Rascal AutoGo Owner's Manual
Installing & Setting the Dashboard Clock
Your Rascal AutoGo comes with a removable, battery-powered, quartz clock that mounts directly in the dash. This clock
is packed separately to allow you to set it to your local time before installing in the dash.
Setting the Clock — Locate the bag containing items packed separately with the vehicle. Unwrap the clock from its
protective packing. If clock includes a small, plastic collar around stem, remove collar and push stem "in" to start clock.
Set clock to your local time by pulling stem out and turning to adjust hour/minute hands. Push stem in to start clock.
Installing the Clock — When you have set the clock to your correct, local time, you can install it in the dash of your
vehicle. Install the clock into the location adjacent to the Speed Control. The rubber gasket is sufficient to secure the
clock in place. Make sure the "12" faces "up."
EMC Part: 19286400 Rev.01 03/09/07
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rascal AutoGo and is the answer not in the manual?
Questions and answers
is there a way to test my rascal autogo onboard battery charger?
To test the onboard battery charger of a Rascal AutoGo, follow these steps:
1. Check the Battery Pack LED – Ensure the LED on the Battery Pack is lit when plugged in.
2. Verify Cord Connections – Make sure the power cord is properly plugged into both the Battery Pack and the electrical outlet.
3. Observe Charging Behavior – If the battery does not charge, load test the batteries to determine if they need replacement.
4. Check for a Faulty Charger – If the Battery Pack LED is not lit and connections are correct, the charger may be defective. Contact Electric Mobility or an Authorized Service Center for further assistance.
This answer is automatically generated