Initial Setup And Adjustments; Charging Batteries - Rascal R6 300 Owner's Manual

The tiller used on the 4-Wheel Chair model is available in left hand or right hand configurations and
includes the following controls:
Right Hand Operation
Left Hand Operation
Other controls mounted on the tiller operate exactly as controls on the dash.

Initial Setup and Adjustments

Before using your Rascal scooter, you should perform the following initial setup and adjustments to
ensure that you are as comfortable as possible. The setup and adjustments include:
• Charging the Battery
• Adjusting the Seat
• Adjusting the Handlebar Assembly and Dash Position
• Setting the Dashboard Clock

Charging Batteries

Because your batteries may only have a partial charge when you first receive your scooter, you may not
experience full riding time until you have fully charged them. Your scooter is equipped with an on-
board battery charger. Charging your batteries as specified will ensure maximum life, power, and range.
It is recommended that you charge your batteries as follows:
• Upon initial receipt of your R6 300.
• For 8-10 hours (overnight) after daily use, regardless of battery level.
• If the fuel gauge indicator should go into the red area while operating your vehicle, the batteries
need to be recharged as soon as possible.
• The battery's life expectancy may be shortened if they are left fully discharged for more than 24
hours.
Rascal R6 300 Scooter Owner's Manual
FORWARD Pulling the Speed Engager Lever on the right towards
you moves the vehicle forward.
REVERSE Pulling the Speed Engager Lever on the left towards you
moves the vehicle in reverse.
FORWARD Pulling the Speed Engager Lever on the left towards you
moves the vehicle forward.
REVERSE Pulling the Speed Engager Lever on the right towards
you moves the vehicle in reverse.
EMC Part: 19277200 • Rev. 06 • 09/04/2007
10