Instructions For The Installer - EURO EG90GFSX Operating And Installation Instructions

MAINTENANCE
Prior to any maintenance work or changing
parts, disconnect the appliance from the gas
and electricity power sources. Servicing must
only be carried out by authorised personnel.
REPLACING THE TAPS AND THERMOSTAT
Proceed in the following way when replacing a tap or
thermostat :
• Remove pan supports, burner heads.
• Unscrew the burner fixing screws (Vc) (fig. 23).(four
for ultrarapid burner and two for the other burners)
• Remove the hob, unscrewing frontal and rear
fixing screws (Vs) (fig. 23) which lock the hob at
the supports (S).
• Pull out the knobs.
• Unscrew the nuts (D) of the gas aluminium pipes
and pull out the thermocouple quick connectors (F)
(fig. 24).
• Unscrew the screws (Vt) (fig. 24) which lock the
crosspieces.
• Unscrew the screws (Vb) (fig. 24) which unite the
the bridles of the taps to the front frame.
• Make to slip the ramp toward the back part and
unscrew the screws (Vb) (fig. 25) in order to free the
taps.
• Change seal each time a tap or a thermostat
is replaced. This will ensure perfect retention
between the tap or a thermostat and part•
Reassemble all the parts following the same
procedure but in the reverse order.

INSTRUCTIONS FOR THE INSTALLER

REPLACING THE ELECTRICAL COMPONENT
• The rear protection will have to be removed in
order to change the electrical heating elements,
spit motor, terminal board and power cable.
• If you have to change the power cable (see
TECHNICAL FEATURES paragraph), always
keep the earth wire longer than the phase wires
and, in addition, follow all the instructions
given in the "ELECTRICAL CONNECTION"
paragraph.
• To change the oven lamp see the instructions
REPLACING THE OVEN LAMP paragraph.
• To change lamp holder (P) (fig. 26), use a
screwdriver to push the clamp tips (M) and pull the
lamp holder out towards the inside of the oven.
• To change the lamp holder, the spark generator
and the spark electrodes, the work top has
to be removed as indicated in the paragraph
«REPLACING THE TAPS».
• To change the programming accessory, the
thermostat, the commutator and the warning lights,
remove the front panel by unscrewing the three
fixing screws which lock it to the front frame.
26
�
�
26