EURO EG60FS A Manual To Use, Installation And Regulation

Hide thumbs

Table Of Contents

Quick Links

A GUIDE TO USE,

INSTALLATION AND REGULATION

OF YOUR COOKERS

Model: EG60FS

Model: EG600FS2X

aus

MANUFACTURED BY: TECNO spa

Table of Contents

Need help?

Do you have a question about the EG60FS and is the answer not in the manual?

Questions and answers

Summary of Contents for EURO EG60FS

Page 1 A GUIDE TO USE, INSTALLATION AND REGULATION OF YOUR COOKERS Model: EG60FS Model: EG600FS2X MANUFACTURED BY: TECNO spa...
Page 2: Table Of Contents
The appliance was designed and made in accordance with the European standards listed below: => EN 30-1-1, EN 30-2-1 and EN 437 plus subsequent amendments (gas) => EN 60 335-1 and EN 60 335-2-6 (electrical) plus relative amendments appliance complies with the prescriptions of the European Directives as below: =>...
Page 3: Assistance And Spare Part
ASSISTANCE AND SPARE PARTS Before this appliance left the factory it was tested and set by specialized, expert personnel in order to guarantee the best functioning results. Any subsequent repairs or adjustments that may be necessary must be done with the maximum of care and attention by authorised personnel.
Page 4: Important Notes And Precautions For Use
IMPORTANT NOTES AND PRECAUTIONS FOR USE You have purchased one of our products for which we There are a few basic rules that must be observed thank you. We are confident that this new appliance, when using the appliance: modern, functional and practical, made with top quality =>...
Page 5: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE PRESENTATION Our cooker is fitted with a fully gas hotplate. This innovative burner hotplate offers you more scope and versatility in hotplate cooking than ever before. The round burners are graduated in their size and output �...
Page 6 DESCRIPTION OF THE APPLIANCE CONTROLS HOB GAS BURNER KNOB (A) By rotating the knob in an anticlockwise direction, the following symbols appear: = Closed position = “Full on” position = “Reduced rate or Low” position � � � GAS OVEN/GRILL THERMOSTAT KNOB (B) By rotating the knob in an anticlockwise direction, the following functions appear: = Closed position...
Page 7 DESCRIPTION OF THE APPLIANCE HOB: GENERAL NOTES ON SAFETY ABNORMAL OPERATION Any of the following are considered to be abnormal • When using the burners, do not leave the appliance unsupervised. Ensure that children and the infirm operation and may require servicing: do not play with the appliance.
Page 8: Instructions For The User
INSTRUCTIONS FOR THE USER OVEN: GENERAL SAFETY INSTRUCTIONS WHAT TO DO THE FIRST TIME YOU USE THE OVEN • Do not leave the oven unsupervised during use. • Remove all protective wrapping materials from the Ensure that children and the infirm do not play with appliance and labels from the oven door.
Page 9 INSTRUCTIONS FOR THE USER or roasting purposes and it can interfere with heat HOW TO USE GAS OVEN AND GAS GRILL distribution in the oven. AUTOMATIC ELECTRIC IGNITION OF OVEN • Slightly more heat is generated from the bottom of the BURNER oven upwards, with the top shelf being the marginally Electric ignition is achieved by firstly, fully opening...
Page 10 INSTRUCTIONS FOR THE USER TIME AND TEMPERATURE CHART The above table gives guidelines for cooking a range of different foods, individual food, or personal preferences may slightly vary the oven position, temperature and cooking time from those suggested. Please note that: •...
Page 11 INSTRUCTIONS FOR THE USER AUTOMATIC ELECTRIC IGNITION OF THE GRILL • With gas grill the oven door must be left BURNER partially opened at its preset hold position and Automatic ignition is achieved by firstly, fully opening you must ensure that the protective heat guard the oven door and then pushing and turning the gas (fig.
Page 12 INSTRUCTIONS FOR THE USER USEFUL COOKING TIPS Meat: • If, when cooking meat, the time needed is more than 40 minutes, turn the oven off 10 minutes Cakes and bread: before the end of cooking time to exploit the • Heat the oven for at least 15 minutes before you residual heat (energy saving).
Page 13 INSTRUCTIONS FOR THE USER CLEANING AND MAINTENANCE STRUCTURE All the cooker parts (in enamelled or painted metal, • Prior to any maintenance work or cleaning, steel, or glass) should be cleaned frequently with disconnect the appliance from the electricity warm soapy water and then rinsed and dried with a mains.
Page 14 INSTRUCTIONS FOR THE USER OVEN DOOR REMOVAL The oven door can be removed to give easier access to the oven when cleaning. To remove, proceed as follows: Hinges type 1 • Open the oven door and move the release U-shape element (fig.
Page 15: Troubleshooting
INSTRUCTIONS FOR THE USER REPLACING THE OVEN LAMP Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.. In the event one or both oven lamps need replacing, the new lamps must comply with the following requisites: 15 W - 230 V~ - 50 Hz - E 14 - and must be resistant �...
Page 16: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER Ensure that the kitchen is well ventilated; keep TECHNICAL INFORMATION natural ventilation holes open or install a mechanical ventilation device (mechanical extraction hood). The installations, conversions and maintenance Prolonged intensive use of the appliance may call for operations listed in this part must only be carried additional ventilation, for example increasing the level out by authorised personnel.
Page 17: Assembly Instructions
INSTRUCTIONS FOR THE INSTALLER LEVELLING THE COOKER WARNING: If the cooker is installed between two • Adjustable feet, to be fitted to the appliance, which cupboards and the stabilising chains cannot be allow the height of the cooker to be aligned with installed to stabilise the cooker, please contact our other kitchen furniture This can be done by means Service Centre.
Page 18 INSTRUCTIONS FOR THE INSTALLER with AS5601 for a high level connection. The hose GAS CONNECTION should not be subjected to abrasion, kinking or This appliance shall be installed only by authorised permanent deformation and should be able to be personnel and in accordance with the manufacturer’s inspected along its entire length.
Page 19 INSTRUCTIONS FOR THE INSTALLER ELECTRICAL CONNECTION ADJUSTMENTS The electrical connection must be carried out in • Always disconnect the appliance from accordance with the current standards and laws the electricity supply before making any in force and by an authorised electrician. adjustment.
Page 20 INSTRUCTIONS FOR THE INSTALLER OVEN THERMOSTAT (fig. 22) Reduced rate adjustment should be carried out in the following way: • Remove the knob thermostat. • Switch on the oven burner by turning the relative knob to the Maximum position, then wait about 10 minutes.
Page 21 INSTRUCTIONS FOR THE INSTALLER GAS CONVERSIONS NOTE: Grill or Oven Failure When converting from Natural Gas to Propane ensure • Check thermocouple terminal. that the NG regulator is removed and replaced with the • Inspect rear of thermostat (under hob) to check that Test Point Assembly.
Page 22 INSTRUCTIONS FOR THE INSTALLER MAINTENANCE REPLACING THE ELECTRICAL COMPONENTS • The rear protection will have to be removed in order Prior to any maintenance work or changing to change the lamp holder, terminal board and parts, disconnect the appliance from the gas power cable.
Page 23: Technical Features
BURNER TECHNICAL DATA TABLE OPERATING DIAMETER BURNER RATING PRESSURE INJECTORS DENOMINATION MJ/h 1/100 mm Ultrarapid Left fron Propane 2.75 13.3 Natural 1.00 13.3 EG60FS Ultrarapid Left front Propane 2.75 11.5 Natural 1.00 11.0 EG600FS2X Small Propane 2.75 Right rear Natural 1.00 Small Propane 2.75...

This manual is also suitable for:

Eg600fs2x