Table of Contents
Advertisement
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Centre please check the following chart.
PROBLEM
The appliance is not working
The thermostat is not working
The oven light does not switch on
Warning: Servicing should be carried out only by authorised personnel.
TECHNICAL INFORMATION
The installations, conversions and maintenance
•
operations listed in this part must only be carried
out by authorised personnel. The manufacturer
cannot be held responsible for any damage to
persons or property resulting from an incorrect
installation of the appliance.
If the appliances is installed on a base ,
•
measures must be taken to prevent the
appliance from slipping from the base
The appliance is not intended to be operated by
•
means of an external timer or separate remote-
control system.
• The safety and automatic adjustment devices of the
appliances may, during its life, only be modified by
the manufacturer or duly authorised supplier.
•
This appliance shall be installed only by
authorised personnel and in accordance with
the manufacturer's installation instructions, local
gas fitting regulations, municipal building codes,
electrical wiring regulations, AS 5601 - Gas
Installations and any other statutory regulations.
• Failure to install the appliance correctly could
invalidate any manufactures warranty and lead to
prosecution under the above quoted regulation.
• Before installation, make sure that local distribution
conditions (gas and electrical) are compatible with
the appliance's adjustment. Refer to data label for
gas type.
• As it is not connected to a device for the evacuation
of the products of combustion, it must be installed in
accordance with current regulations and used in a
well ventilated location. Particular attention must be
paid to the regulations on ventilation.
TROUBLESHOOTING
• Make sure the gas cock is open
• Check the plug is in
• Check that the knobs are set correctly for cooking and then repeat the
operations given in the handbook
• Check the electrical system safety switches (RCD). If there is failure in
the system call an electrician in.
• Contact Service Centre..
• Make sure the lamp is firmly screwed in place
• Buy a lamp for high temperatures at one of our Service Centre and fit it
following the instructions given the <REPLACING THE OVEN LAMP>
paragraph.
INSTRUCTIONS FOR THE INSTALLER
REMEDY
VENTILATION
All rooms require an openable window or equivalent,
while some rooms require a permanent vent in addition
to the openable window.
Ventilation must be in accordance with AS5601 - Gas
Installations. In general, the appliance should have
adequate ventilation for complete combustion of gas,
proper flueing and to maintain temperature of immediate
surroundings within safe limits.
The use of a gas appliance results in production of heat
and moisture in the room in which it is installed. Ensure
that the kitchen is well ventilated; keep natural ventilation
holes open or install a mechanical ventilation device
(mechanical extraction hood).
Prolonged intensive use of the appliance may call for
additional ventilation, for example increasing the level of
mechanical ventilation where present.
UNPACKING YOUR COOKER
• Once the packaging has been removed, thoroughly check
that the appliance is in perfect condition. If you have any
doubts do not use the appliance and call our Service
Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are protected by a
plastic film. This protection must be removed before using
the appliance. We recommend slitting the plastic film along
the edges with a sharp knife or pin.
The packaging materials used (cardboard,plastic
bags, polystyrene foam, nails etc.) must not be left
anywhere within easy reach of children as they are a
potential hazard source.
19
Hide quick links:
Advertisement
Table of Contents
