EURO EG90GFSX Operating And Installation Instructions page 20

POSITION (fig. 14)
The appliance should be positioned in good light and
free from draughts. Any adjoining wall surface situated
within 200 mm from the edge of any hob burner must be
a suitable non-combustible material for a height of 150
mm for the entire length of the hob. Any combustible
construction above the hotplate must be at least 750
mm above the top of the burner and no construction
shall be within 450 mm above the top of the burner.
Where a combustible surface adjacent to the cooker
is less than 200 mm from the nearest burner it may
be protected by a non-combustible protective layer in
accordance with AS5601. The protection must ensure
the surface temperature of the combustible surface
does not exceed 65º C above ambient.
���������
INSTRUCTIONS FOR THE INSTALLER
� �
� � �
�
14
16
LEVELLING THE COOKER
• Adjustable feet, to be fitted to the appliance, which
allow the height of the cooker to be aligned with
other kitchen furniture This can be done by means
of the terminal part of the leg themselves (fig. 16)
• Backguard. The cookers which are equipped
with this accessory, leave the factory with this part
inserted inside the packaging. In order to install the
backguard, it is necessary to loosen the screws
positioned on the back of the hob and then to fix the
backgaurd as indicated in figure 17.
OVERALL DIMENSIONS (fig. 15)
�
� �
� �
�
�
20
� �
15
17
�