Gas Connection - EURO EG90GFSX Operating And Installation Instructions

GAS CONNECTION

This appliance shall be installed only by authorised
personnel and in accordance with the manufacturer's
installation instructions, local gas fitting regulations,
municipal building codes, water supply regulations,
electrical wiring regulations, AS 5601 - Gas Installations
and any other statutory regulations.
The appliance is adjusted to work at gas indicated on
the label which is applied on the glass-window of the
oven door and on the cooker packing.
Installation for Natural gas
Connected regulator (B) to fitting (A) which is then fitted
to elbow (F). Ensure arrow on regulator point in the
direction shown. Fitting (D) to be supplied by installer
(fig. 18). Adjust regulator to give test-point pressure
given on data label on <TECHNICAL FEATURES>
paragraph, with one large or one medium burner
alight at maximum.
Position of Regulator (fig. 18)
The stove must be installed on legs, a gas pipe
between fitting (A) and (B) will allow location of the
regulator (B) underneath the stove for adjustment and
maintenance.
Installation for Propane Gas (fig. 18A)
Connect by using a copper pipe starting, from the threaded
fitting of elbow (F) .
Installation using flexible connection
As an option, the cooker may be installed with a
flexible connection hose, which complies with AS/
NZS 1869 (AGA Approved), 10 mm ID, class B or
D, Minimum 1000 mm - Maximum 1200 mm, as an
alternative connection.
• All cookers offer left or right hand connection. The
manifold has a flat flair over which is inserted a
screw nut male ½" gas (fig. 18B).
• An isolating tap and pressure regulator must be
fixed to the rear wall and the flexible pipe attached
by means of a union connector.
• The gas connection and isolating tap must be
accessible to a service person or inspector.
• The hose assembly must be installed in accordance
with AS5601 for a high level connection. The hose
should not be subjected to abrasion, kinking or
����������
�����������
�������������
�������������
INSTRUCTIONS FOR THE INSTALLER
permanent deformation and should be able to be
inspected along its entire length. Unions compatible
with the hose fittings must be used and connections
tested for gas leaks. The fixed consumer piping
outlet should be at approximately the same height as
the cooker connection point, pointing downwards.
• The hose should be clear of the floor when the
cooker is in the installed position. The anti-tilting
chain supplied should be anchored to the lower
hook fixed to the wall so that the chain prevents
strain on the hose connections when the cooker is
pulled forward.
Note: When the regulator is fitted at the rear of
the cooker at least 60 mm clearance is required.
� �
�
�
�
�
����������������
�������������
�������������
�������������
����������
�����������
�������������
22
�
�
�
�
�
18
�����
�����������
�
18A
�����
18B
�������������