EURO GU 80 NG Installation And Regulation

Euro gu 80 ng; eg80f cookers

Hide thumbs

Table Of Contents

A GUIDE TO USE,

INSTALLATION AND REGULATION

OF YOUR COOKER

Models: EGU 80 NG - EG80FS

AUS

MANUFACTURED BY: TECNOGAS

Table of Contents

Need help?

Do you have a question about the GU 80 NG and is the answer not in the manual?

Questions and answers

Summary of Contents for EURO GU 80 NG

Page 1 A GUIDE TO USE, INSTALLATION AND REGULATION OF YOUR COOKER Models: EGU 80 NG - EG80FS MANUFACTURED BY: TECNOGAS...
Page 2: Table Of Contents
The appliance was designed and made in accordance with the European standards listed below: => EN 30-1-1, EN 30-2-1 and EN 437 plus subsequent amendments (gas) => EN 60 335-1 and EN 60 335-2-6 (electrical) plus relative amendments The appliance complies with the prescriptions of the European Directives as below: =>...
Page 3: Assistance And Spare Part
ASSISTANCE AND SPARE PARTS Before this appliance left the factory it was tested and set by specialized, expert personnel in order to guarantee the best functioning results. Any subsequent repairs or adjustments that may be necessary must be done with the maximum of care and attention by authorised personnel.
Page 4: Important Notes And Precautions For Use
IMPORTANT NOTES AND PRECAUTIONS FOR USE You have purchased one of our products for which we There are a few basic rules that must be observed thank you. We are conﬁ dent that this new appliance, when using the appliance: modern, functional and practical, made with top quality =>...
Page 5: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE PRESENTATION Our cooker is ﬁ tted with a fully gas hotplate. This innovative burner hotplate offers you more scope and versatility in hotplate cooking than ever before. The round burners are graduated in their size and output to provide the exact heat required for every style of cooking.
Page 6 DESCRIPTION OF THE APPLIANCE DESCRIPTION OF THE CONTROLS ELECTRONIC CLOCK (E) This accessory functions as a clock and a minute counter. The digital display (L) always shows the time HOB GAS BURNER KNOB (A) but will display the minute counter time when this By rotating the knob in an anticlockwise direction, the function is set.
Page 7: Instructions For The User
INSTRUCTIONS FOR THE USER HOB: GENERAL NOTES ON SAFETY OPTIMUM USE OF COOKTOP BURNERS In order to achieve maximum efﬁ ciency with minimum • When using the burners, do not leave the appliance gas consumption it is useful to remember: unsupervised.
Page 8: Instructions For The User
INSTRUCTIONS FOR THE USER...
Page 9 INSTRUCTIONS FOR THE USER OVEN: GENERAL SAFETY INSTRUCTIONS • Do not leave the oven unsupervised during use. Ensure that children and the inﬁ rm do not play with the appliance. • Always keep the appliance lid open when using the ovenor grill burner, in order to prevent overheating. •...
Page 10 INSTRUCTIONS FOR THE USER HOW TO USE GAS OVEN AND GAS GRILL The appliance is equipped with an aluminium shield (S), which works in order to obtain a burnishing uniform above all during the baking of cakes and biscuits. The shield must be correctly positioned on the oven bottom plate (see ﬁ...
Page 11 INSTRUCTIONS FOR THE USER USING THE OVEN Having ignited the oven, the gas control knob should be adjusted to the desired temperature and the oven door left open for 2 to 3 minutes and then gently close the door to avoid extinguishing the ﬂ ame. Preheat the oven for approximately 15 minutes.
Page 12 INSTRUCTIONS FOR THE USER TIME AND TEMPERATURE CHART Because of the large capacity of the oven, higher temperature are used; i.e. 10-15°C higher than in a standard oven. This general description of the oven setting will help you: cool oven 125-140°C moderately hot 210-220°C...
Page 13 INSTRUCTIONS FOR THE USER USING THE GRILL AUTOMATIC ELECTRIC IGNITION OF THE GRILL • The grill is located in the top of the oven and makes BURNER for an extremely versatile and controllable method Automatic ignition is achieved by ﬁ rstly, fully opening of cooking.
Page 14 INSTRUCTIONS FOR THE USER CLEANING AND MAINTENANCE • Prior to any maintenance work or cleaning, disconnect the appliance from the electricity mains. • Do not use a steam cleaner to clean a hob, oven or range. • Do not wash the parts if they are still hot. •...
Page 15 INSTRUCTIONS FOR THE USER STRUCTURE All the cooker parts (in enamelled or painted metal, steel, or glass) should be cleaned frequently with warm soapy water and then rinsed and dried with a soft cloth. DO NOT use harsh abrasive cleaners or sharp metal scrapers to clean the oven glass door since they can scratch the surface, which may result in shattering of the glass.
Page 16: Troubleshooting
TROUBLESHOOTING Some problems can be caused either as the results of simple maintenance operations or by incorrect selection of settings. Prior to contacting a Service Centre please check the following chart. PROBLEM REMEDY The appliance is not working • Make sure the gas cock is open •...
Page 17: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER TECHNICAL INFORMATION The installations, conversions and maintenance operations listed in this part must only be carried out by authorised personnel. The manufacturer cannot be held responsible for any damage to persons or property resulting from an incorrect installation of the appliance. •...
Page 18 INSTRUCTIONS FOR THE INSTALLER POSITION (ﬁ g. 17) The appliance should be positioned in good light and free from draughts. Any adjoining wall surface situated within 200 mm from the edge of any hob burner must be a suitable non- combustible material for a height of 150 mm for the entire length of the hob.
Page 19 INSTRUCTIONS FOR THE INSTALLER SECURING THE COOKER TO WALL (ﬁ g. 19) Note:- The installation of the chain provided is for safety reasons, it must be installed as indicated below. To prevent the cooker tipping forwards in the event of children standing on the oven door or where users put extreme weight on the door when in open position, two lengths of chain MUST BE ﬁ...
Page 20 INSTRUCTIONS FOR THE INSTALLER GAS CONNECTION This appliance shall be installed only by authorised personnel and in accordance with the manufacturer’s installation instructions, local gas ﬁ tting regulations, municipal codes, electrical wiring regulations, AS 5601 - Gas Installations and any other statutory regulations. The appliance is adjusted to work at gas indicated on the label which is applied on the glass-window of the oven door and on the cooker packing.
Page 21 INSTRUCTIONS FOR THE INSTALLER ELECTRICAL CONNECTION The electrical connection must be carried out in accordance with the current standards and laws in force and by an authorised electrician. • Warning this appliance must be earthed. • Connection to the electricity supply must be made by an authorised electrician to a suitable isolating switch in accordance with the requirements of SAA Wiring Rules, AS/NZS 3000.
Page 22 INSTRUCTIONS FOR THE INSTALLER OVEN BURNER (ﬁ g. 24) The burner is installed on the oven base and is covered by the bottom plate which must always remain in that position during oven operation, To adjust the primary air, is performed when the burner is ignited, by adjusting the sleeve (B) and unscrewing screw (A).
Page 23 INSTRUCTIONS FOR THE INSTALLER NOTE: GAS CONVERSIONS Grill or Oven Failure When converting from Natural Gas to Propane ensure • Check thermocouple terminal. that the NG regulator is removed and replaced with the • Inspect rear of thermostat (under hob) to check that Test Point Assembly.
Page 24: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER MAINTENANCE Prior to any maintenance work or changing parts, disconnect the appliance from the gas and electricity power sources. REPLACING THE TAPS AND THERMOSTAT Proceed in the following way when replacing a tap or the thermostat: •...
Page 25: Technical Features
TECHNICAL FEATURES BURNER DISPOSITION BURNER TECHNICAL DATA TABLE OPERATING DIAMETER BURNER RATING PRESSURE INJECTORS DENOMINATION MJ/h 1/100 mm Large rapid Propane 2.75 10.5 Left front Natural 1.00 11.2 Rapid Propane 2.75 Right rear Natural 1.00 Semirapid Propane 2.75 Left rear Natural 1.00 Auxiliary...
Page 26 TECHNICAL FEATURES SPACE RESERVED FOR THE APPLICATION OF THE ELECTRICAL WIRING DIAGRAM LABEL...

This manual is also suitable for:

Eg80f

EURO GU 80 NG Installation And Regulation

Table of Contents

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for EURO GU 80 NG

Summary of Contents for EURO GU 80 NG

This manual is also suitable for:

Table of Contents