4.2
Removing and Replacing the Housing Cover
This section tells you how to open the housing cover when you need to install additional components inside the
system unit.
4.2.1
Removing the Housing Cover
1. Turn off power to the system unit and unplug all cables.
2. Place the system unit on a flat, steady surface.
3. Remove three screws from the rear panel. Set the screws aside. You will need them when replacing the
housing cover.
Figure 4-1 Removing the Screws
4. Push the housing cover slightly backward as indicated in Figure 4-2.
AcerPower 2100 (V66LT/IDB3-C) User's Guide
92
Before you proceed, make sure that you
have
turned
off
the
peripherals connected to it.
4.1.2 for pre-installation instructions.
system
and
all
Read section