Post-Installation Instructions; Removing And Replacing The Housing Cover; Removing The Housing Cover - Acer AcerPower 6000 Options Manual

4.1.3

Post-installation Instructions

Observe the following after installing a system component:
1. See to it that the components are installed according to the step-by-step
instructions in their respective sections.
2. Make sure you have set all the required jumpers. See section 2.3.2 for the
correct jumper settings.
3. Replace any expansion boards or peripherals that you removed earlier.
4. Replace the system cover.
5. Connect the necessary cables and turn on the system.
4.2 Removing and Replacing the Housing
Cover
This section tells you how to open the housing cover when you need to install
additional components inside the system unit.
4.2.1

Removing the Housing Cover

1. Turn off power to the system unit and unplug all cables.
2. Place the system unit on a flat, steady surface.
Before you proceed, make sure that you have
turned off the system and all peripherals
connected to it.
preinstallation instructions.
Read section 4.1.2 for
Chapter 4 - Installing Optional Components 4-3