System Error Messages - Acer Power 2100 User Manual

Table 1-1

System Error Messages

Error Message
Bad CMOS Battery
CMOS Checksum
Error
Floppy Drive
Controller Error
Floppy Drive Error
*
DRAM Configuration
Error
Equipment
Configuration Error
Hard Disk Controller
Error
Hard Disk 0 (1, 2, 3)
Auto Detection
Failed
I/O Parity Error
PS/2 Keyboard
Error or No
Keyboard
Connected
PS/2 Keyboard
Interface Error
Memory Error
Memory Size
Mismatch
*
If the system is equipped with this feature
Corrective Action
Replace battery. Contact your dealer.
Run Setup. See Chapter 3.
Check and connect the cable to the floppy
drive or controller.
Check CMOS setup configuration.
Floppy may be bad. If not, check the
floppy drive and replace if necessary.
Check and modify DRAM configuration to
agree with Table 4-1.
Run Setup. See Chapter 3.
Check and connect the cable to the hard
disk drive or controller.
Check the HDD cable connections and
CMOS setup configuration.
Contact your dealer.
Check that the keyboard is connected to
the system unit.
Disconnect and reconnect the keyboard.
Contact your dealer.
Check DIMMs on the system board.
Contact your dealer.
Run Setup. See Chapter 3.
Index
35