Table of Contents
Advertisement
3.6
Power Management
The Power Management menu lets you configure the system power-management feature.
The following screen shows the Power Management parameters and their default settings:
Power Management Mode
IDE Hard Disk Standby Timer ...... [Off]
System Sleep Timer ............... [Off]
Sleep Mode ..................... [----]
Power Switch < 4 Sec. ............... [Power Off]
System Wake-Up Event
Modem Ring Indicator .............. [Disabled]
3.6.1
Power Management Mode
This parameter allows you to reduce power consumption. When this parameter is set to Enabled, you can
configure the IDE hard disk and system timers. Setting it to Disabled deactivates the power-management feature
and its timers.
IDE Hard Disk Standby Timer
This parameter allows the hard disk to enter standby mode after inactivity of 1 to 15 minutes, depending on your
setting. When you access the hard disk again, allow 3 to 5 seconds (depending on the hard disk) for the disk to
return to normal speed. Set this parameter to Off if your hard disk does not support this function.
Power Management
.............. [Enabled ]
Index
71
Advertisement
Chapters
Table of Contents
