Acer Power 2100 User Manual page 78

3. Highlight the Setup Password parameter and press
Enter your new Password twice.
may be up to 7 characters long.
Enter Password ..................[XXXXXXX]
Enter Password again ............[XXXXXXX]
Set or Change Password
4. Type a password. The password may consist of up to seven characters. Then press
5. Retype the password then press
6. After setting the password, highlight the Set or Change Password option.
7. Press to return to the System Security screen.
8. Press to return to the main menu.
9. Press to exit the BIOS utility. A dialog box appears asking if you want to save the CMOS data.
10. Select Yes to save the changes and reboot the system.
11. After rebooting, turn off the system then open the housing.
12. Set switch no. 2 of SW1 to On to enable the password function.
The next time you want to enter the BIOS utility, you must key-in your Setup password.
Changing or Removing the Setup Password
Should you want to change your setup password, do the following:
AcerPower 2100 (V66LT/IDB3-C) User's Guide
78
Setup Password
Password
Be very careful when typing your password
because the characters do not appear on the
screen.
.
or . The following screen appears:
.