Installing A Pentium Ii Processor; Inserting The Clip Ends Into The Processor Holes - Acer Power 2100 User Manual

4.7.2

Installing a Pentium II Processor

Observe the ESD precautions when installing or
removing a system component. See section 4.1.1
Before you proceed, make sure that there is no processor installed in the CPU connector.
Follow these steps to install a Pentium II processor:
1. Remove the processor card from its protective packaging. Make sure that the latches on the sides of the
module are not pressed.
2. Insert the clip ends into the holes on the processor as shown below.
Figure 4-16 Inserting the Clip Ends into the Processor Holes
Index
107