3.
Replace any expansion boards or peripherals that you removed earlier.
4.
Replace the system cover.
5.
Connect the necessary cables and turn on the system.
4.2
Removing and Replacing the Housing
Cover
This section tells you how to open the housing cover when you need to install
additional components inside the system unit.
4.2.1
Removing the Housing Cover
1.
Turn off power to the system unit and unplug all cables.
2.
Place the system unit on a flat, steady surface.
3.
Remove the four screws from the rear panel. Set the screws aside. You will
need them when replacing the housing cover.
Before you proceed, make sure that you
have
turned
off
peripherals connected to it.
4.1.2 for pre-installation instructions.
the
system
and
Read section
Chapter 4 - Installing Optional Components
all
4-3