Ready Mode
The HT630 performs a Power-On-Test and Warm-Start when it is switched on. After
the Warm Start, the system enters Ready Mode and shows the Ready Mode Prompt.
Ready Mode Prompt
HT630 Vx.xx
MEM 4608KB
>
User Mode and System Commands
There are eight system commands: RUN, TER, COM, DIR, ERA, TYP, CPY, and SET.
Each command can be entered through menu-selection in User Mode. Users can
press the
key for two seconds in Ready Mode to enter User Mode.
User Mode Prompt
1.RUN
2.TER
3.COM
4.DIR
5.ERA
6.TYP
7.CPY
8.SET
RUN
When you invoke the RUN command, you may press
to toggle to the loaded program and hit
The program may also be executed on the HT630 by entering the
program name directly in Ready Mode.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
The first line indicates the model code and version number (e.g.
V1.00). The second line shows the size of the total installed RAM
(i.e. 4608 KB). The third line prompts a ">" which indicates that the
terminal passed the Power-On-Test and is ready to be used.
Select the corresponding number, 1-8, or press (
to highlight a command then hit
Pressing the
key returns to Ready Mode.
21
to select a system command.
(
)
to run the program.
)