Operation; Overview - Unitech HT630 Reference Manual

Overview

The HT630 has several operating modes to optimize performance for various
purposes. The diagram below shows the operating flow of the HT630 and summarizes
how to switch between different modes.
enter
'Program
Name'
then press
APPLICATION
mode
System configurations are categorized in two groups. Users can select the "8.SET"
command in User Mode to set general system configurations or enter Supervisor
Mode to set advanced system configurations. The Supervisor Mode is password
protected to prevent unauthorized personnel from changing system configurations.
The default password for Supervisor Mode is "630".
It is likely that your HT630 came configured by your software vendor or system
developer. If this is the case, please use caution when changing these settings.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

Operation

OFF
press
HT630 V1.00
MEM 512KB
>
press
(for two
seconds)
1.RUN
3.COM
5.ERA
RUN
command
7.CPY
USER
mode
Press and hold down
then press
press
press
2.TER
4.DIR
6.TYP
8.SET
20
Chapter 3
and keys
<<START MENU>>
1.SUPERVISOR
2.WARM START
3.COLD START
press
SUPERVISOR
mode