Changing Paper & Print Ribbon; Changing/Installing The Printer Ribbon Cartridge; Loading The Receipt Printer - Samsung SER-6500II Series Operator's Manual

Changing Paper & Print Ribbon

Changing/Installing the Printer Ribbon Cartridge

The Samsung SER-6500II/6540II receipt/journal printer uses a replaceable ink ribbon
cartridge. This cartridge must be in place (as well as the logo stamp) when changing the receipt
and journal paper, or the paper will not feed properly through the printer. Once installed, if
print becomes faint, the ink ribbon must be replaced.
To Replace the Ink Ribbon
1. Remove the printer cover and locate the ink
ribbon cartridge as shown in the illustration.
2. Apply downward pressure to the cartridge
while pulling it towards you using the
serrated area on the left edge and the raised
tab near the knob on the right. Lift to
remove.
3. Insert the new ink ribbon cartridge and press
firmly into place. Remove any slack in the
ribbon by rotating he cartridge knob counter-
clockwise.

Loading the Receipt Printer:

* Ribbon and logo stamp must be in place when changing paper.
1. Place the other roll of paper into the small tray on the left.
2. Make sure the paper unrolls from the bottom of the roll.
3. Fold back approximately 6" of paper and insert the folded end of the tape into the feed slot
just in front of the paper tray at the rear of the
printer.
4. Press the RECEIPT FEED switch until the paper
comes through the printer. Continue to press the
switch until 3 - 4 inches of paper are through the
printer.
5. Replace the printer cover, making sure the receipt
paper comes out through the opening in the printer
cover.
18 • Introduction
SER-6500II/6540II Program Manual