Clearing A Paper Jam - Samsung SER-6500 Service Manual

5 Alignments and Adjustments
Paper Remnant (m):
5
7~ NY WwW A
#1 #2 #3 «#4 °~«#5
——+
Figure 5-2. Relationship: Adjustment Scale to
Remnant Length
Note: Figure 5-2 applies only when using
Samsung recommended paper.
Figure 5-3 shows the relationship between the
Adjustment Scale and the outer diameter of the
Winding Core.
Adjustment Scale:
#5
#4
#3
#2
#1
10 15 20 2 30
———> _ outer diameter of Paper
Winding Core (©: mm)
iv
a
D: Outer Diameter
d: Inner Diameter
Figure 5-3. Relationship: Adjustment Scale to
Winding Core Diameter
Notes:
1. When using roll paper other than Samsung
recommended paper, roll paper remnant
lengths will differ.
2. When using roll paper with a red end mark,
Winding Core may be pulled out of its holder
due to the paper sticking to Winding Core.
Paper sensor may indicate an inaccurate
remnant length if Winding Core is pulled out
of its holder.
5-1-3 Clearing a Paper Jam
5-1-3 (a) Paper Jamming Causes
1. When more than two papers enter the paper
path.
When paper cutting remnants remain in the
paper exit space.
5-1-3 (b) Clearing Procedure
Caution: Always disconnect the power cord from
the power outlet before working on the
Paper Cutter.
Open the Printer Cover and remove the Auto-
Cutter Cover 2.
Remove all jammed paper at Auto-Cutter.
Replace Auto-Cutter Cover 2 and close Printer
Cover.
The Auto-Cutter will operate as soon as power
is restored to the ECR. After cutting once, the
Auto-Cutter goes to its normal state.
5-2 SER-6500 / SER-6500F / SER-6540/SER-6540F Samsung