Initial Loading Of The Detail Printer - Samsung SER-6500II Series Operator's Manual

Initial Loading of the Detail Printer

* Ribbon and logo stamp must be in place when changing paper.
1. Locate and install ribbon cartridge (as
instructed above).
2. Plug the cash registers power cord into
properly grounded wall socket.
3. Place the key marked REG into the control
lock and turn to the REG position.
4. Locate the printer cover key. The printer
cover key is the smallest key on the key ring.
Insert this key into the printer cover lock.
Turn the key, and remove the printer cover.
5. Locate the 2 pieces for the rewind spindle.
6. As you face the keyboard, notice two plastic
trays at the bottom of the cash register. Place
one of the rolls of printer paper into the tray
on the right. Make sure the paper will
unwind from the bottom of the roll.
7. Fold back approximately 6" of paper and
insert the folded end of the tape into the feed
slot just in front of the paper tray at the rear
of the printer.*
8. Press the DETAIL FEED key on the cash
register keyboard until the edge of the paper
feeds through the printer. Run 6 - 8 inches of
paper through the printer.
9. Insert the end of the paper into the slot on the shaft of the rewind spindle, holding the
spindle with the gear to the right and the shaft to the left. Wind the spindle several turns to
be sure the paper will stay on the spindle. Press the end piece of the rewind spindle back
onto the left end of the shaft.
10. Slide the axle of the rewind spindle (between the gear and the shaft) into the notch of the
printer housing. Make sure the gear on the rewind spindle meshes with the gear on the
printer.
11. Press the DETAIL FEED several more times to make sure the paper moves properly
through the printer.
SER-6500II/6540II Program Manual
Introduction • 19