Introduction; Recommended Tools And Materials; Product Inspection; Contents - ProBoat Miss GEICO 29 PRB4100B Owner's Manual

Introduction

Pro Boat® RC models look as good as they perform. Our boats, which include everything from scale sailboats to
fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your
passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste,
budget and lifestyle. You can count on us to be available any time you need help—the brand is backed by Horizon
Hobby, one of the world's largest distributor of hobby-grade RC products. The Pro Boat brand will help you turn your
boating passion into a reality, whether you're new to the hobby or an old pro. Please read this manual for operation
and maintenance instructions.
Register your boat online at www.proboatmodels.com.

Recommended Tools and Materials

• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 8mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat ® Marine Grease and Gun (PRB0100)
• Li-Po battery (DYNP4000EC) or Ni-MH Battery
(DYN1080EC) (2)
• Li-Po battery charger (DYN4066) or Prophet™
Sport AC/DC Peak Ni-MH Charger (DYN4056)

Specifications

Length 30 in (762mm)
Beam 11 in (279mm mm)
Transmitter Spektrum 2.4GHz
Pistol Grip Transmitter
(DX2E)
Assembling the Boat Stand
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand pieces to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.
Miss Geico 29

Product Inspection

Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby shop where
you purchased your boat or the nearest Horizon Hobby
service center.

Contents

Receiver Spektrum™ MR200
Hull Material Fiberglass Composite
Motor 1500Kv
ESC 60-amp brushless,
water-cooled
Tip: 4 AA batteries (sold
separately) are required to operate
the transmitter. A Li-Po battery
(DYNP4000EC) or Ni-MH Battery
(DYN1080EC) (sold separately) is
required to operate this boat.
EN
3