Introduction; Recommended Tools And Materials; Product Inspection; Contents - ProBoat Shockwave PRB0600 Owner's Manual

Introduction

The Pro Boat ® Shockwave
wave-churning Deep-V hull that's ready to tear up the water. Whether you're new to RC boating or an experienced
pro, the Shockwave 26 brushed boat will take you on an unforgettable ride time after time.
Register your boat online at www.proboatmodels.com.

Recommended Tools and Materials

• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat ® Marine Grease and Gun (PRB0100)

Specifications

length 26 in (660mm)
Beam 4.375 in (111mm)
Transmitter 2.4GHz Pistol
Grip Transmitter

Boat Battery pack(s) Installation

1. Lift the back of the hatch and pull the hatch
backward to remove.
2. Remove the radio box cover.
3. Adhere loop tape (included) to the battery.
Do not cover the battery warning label.
Shockwave 26
® 26 ready-to-run boat is agile on the lake and easy on the eyes. It's a high-performing,
Receiver
Hull Material ABS Plastic
Motor
ESC
1

product Inspection

Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.

Contents

Battery and Charger
DYN4113
2-channel 2.4GHz
DYN1060EC
550 Motor (20 turn)
4 AA batteries (sold separately) are
50 Amp brushed
required to operate the transmitter.
4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop
strap as shown.
2
2A peak charger
6-cell 2400mAh
Ni-MH battery
5
3
4
EN
3