Connecting And Operating The Hdmi Detective Plus - Gefen EXT-HDMI-EDIDP User Manual

CONNECTING AND OPERATING THE HDMI DETECTIVE PLUS

1. Before proceeding, please ensure that the write protect switch is in the E
(write enabled) position and all SETTING DIP SWITCHES are in the OFF (up)
position Please see the diagram on the page 8.
2. Connect the display to the HDMI Out port on the HDMI Detective Plus. Turn on
the display to ensure that an EDID is being transmitted.
3. Plug the supplied 5V DC power supply into the HDMI Detective Plus. The
power LED should be glowing either solid RED (an EDID is not programmed) or
solid GREEN (an EDID is properly programmed).
4. Once you are ready to program the EDID, press and hold the Program button
on the front panel of the HDMI Detective Plus until the unit's LED begins to
rapidly fl ash green. Once the recording sequence is initiated, release the
button and wait until the LED glows a solid green color. A successful EDID
programming sequence is indicated with a green LED while an unsuccessful
EDID record is indicated with a red LED.
NOTE: If the unit does not initiate the recording sequence, indicated by a fl ashing
green LED, please unplug the display and 5V DC power supply from the unit and
repeat steps 2 and 3. If a solid red LED is indicated after several unsuccessful
recording attempts, it is possible that the EDID from the display being recorded is
bad. Please refer to the USING A PRE-PROGRAMMED EDID section on page 6
and 7 for instructions on how to use one of the built in EDID's.
4