Victron energy Quattro 12/5000/200 User's Manual & Installation Manual page 21

DIP switches ds2 and ds1 are reserved for the selection of stand-alone, parallel or 3-phase operation
Step 1: Setting ds2 and ds1 for stand-alone operation
DS-8 AC-in-1 Set as desired
DS-7 AC-in-1 Set as desired
DS-6 AC-in-1 Set as desired
DS-5 AC-in-2 Set as desired
DS-4 Charging current Set as desired
DS-3 Charging current Set as desired
DS-2 Stand-alone operation
DS-1 Stand-alone operation
Examples of DIP switch settings for stand-alone mode are given below.
Example 1 shows the factory setting (since factory settings are entered by computer, all DIP switches of a new product are set to 'off').
Important: When a panel is connected, the AC-in-2 current limit is determined by the panel and not by the value stored in the Quattro.
Four examples of stand-alone settings:
DS-8 AC-in-1
DS-7 AC-in-1
DS-6 AC-in-1
DS-5 AC-in-2
DS-4 Charging current
DS-3 Charging current
DS-2 Stand-alone mode
DS-1 Stand-alone mode
Step1, stand-alone
Example 1 (factory setting):
8, 7, 6 AC-in-1: 30A
5 AC-in-2: 16A
4, 3 Charging current: 75%
2, 1 Stand-alone mode
To store the settings after the required values have been set: press the 'Up' button for 2 seconds (upper button to the right of the DIP
switches, see appendix A, position K). The overload and low-battery LEDs will flash to indicate acceptance of the settings.
We recommend making a note of the settings, and filing this information in a safe place.
You can now re-use the DIP switches to apply the remaining settings (step 2).
off
off
on DS-8 on
on DS-7 on
on DS-6 on
off DS-5 off
on DS-4 on
off DS-3 on
off DS-2 off
off DS-1 off
Step1, stand-alone
Example 2:
8, 7, 6 AC-in-1: 30A
5 AC-in-2: 16A
4, 3 Charging current: 100%
2, 1 Stand-alone mode
DS-8 off
DS-7 on
DS-6 on
DS-5 off
DS-4 on
DS-3 on
DS-2 off
DS-1 off
Step1, stand-alone
Example 3:
8, 7, 6 AC-in-1: 16A
5 AC-in-2: 16A
4, 3 Charging current: 100%
2, 1 Stand-alone mode
DS-8 on
DS-7 on
DS-6 off
DS-5 on
DS-4 off
DS-3 on
DS-2 off
DS-1 off
Step1, stand-alone
Example 4:
8, 7, 6 AC-in-1: 26A
5 AC-in-2: 30A
4, 3 Charging current: 50%
2, 1 Stand-alone mode
20