Table of Contents
Advertisement
TG8051_8061PD(e-hg).book Page 46 Wednesday, February 2, 2011 2:33 PM
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's AC
adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the handset.
General use
Problem
Cause/solution
The handset does not turn on
L Place the handset on the base unit or charger to turn on the handset.
even after installing charged
batteries.
The unit does not work.
L Make sure the batteries are installed correctly (10. oldal).
L Fully charge the batteries (11. oldal).
L Check the connections (10. oldal).
L Unplug the base unit's AC adaptor to reset the unit and turn off the
L The handset has not been registered to the base unit. Register the
The handset display is blank
L The handset is in screen saver mode (15. oldal). Activate the handset
or dark.
L "LCD töltésnél" is set to "KI" while on charge. Change the
L The handset is not turned on. Turn the power on (15. oldal).
I cannot hear a dial tone.
L Make sure that you are using the supplied telephone line cord. Your
L The base unit's AC adaptor or telephone line cord is not connected.
L Disconnect the base unit from the telephone line and connect the line
Programmable settings
Problem
Cause/solution
The display is in a language
L Change the display language (15. oldal).
I cannot read.
While programming, the
L A call matching an entry in the call barred list is being received. Wait
display returns to standby
mode.
I cannot activate the eco
L You cannot set eco mode when you set the repeater mode "BE". If
mode.
46
handset. Reconnect the adaptor, turn on the handset and try again.
handset (30. oldal).
display again by:
– pressing {<} or {>} when on a call.
– pressing {ic} at all other times.
setting (26. oldal).
old telephone line cord may have a different wiring configuration.
Check the connections.
to a known working telephone. If the working telephone operates
properly, contact our service personnel to have the unit repaired. If
the working telephone does not operate properly, contact your
service provider/telephone company.
and try again later.
required, set the repeater mode to "KI" (30. oldal).
Advertisement
Table of Contents
