Table of Contents
Advertisement
TG8051_8061PD(e-hg).book Page 49 Wednesday, February 2, 2011 2:33 PM
Problem
Cause/solution
"FD" is displayed.
L The unit could not connect to the SMS message centre. Confirm that
"FE" is displayed.
L An error occurred while sending the message. Try again.
"E0" is displayed.
L Your phone number is permanently withheld or you have not
Answering system (KX-TG8061)
Problem
Cause/solution
The unit does not record new
L The answering system is turned off. Turn it on (36. oldal).
messages.
L The message memory is full. Erase unwanted messages (37. oldal).
L The recording time is set to "Csak üdv.". Change the setting (40.
L If your own greeting message is not recorded properly, callers are
L If you subscribe to a voice mail service, messages are recorded by
My own greeting message
L Record your own greeting message again (36. oldal).
cannot be properly heard.
I cannot operate the
L Someone is using the unit. Wait for the other user to finish.
answering system.
L A caller is leaving a message. Wait for the caller to finish.
L The handset is too far from the base unit. Move closer.
I cannot operate the
L The remote access code is not set. Set the remote access code (38.
answering system remotely.
L You are entering the wrong remote access code. If you have forgotten
L Press each key firmly.
L The answering system is turned off. Turn it on (39. oldal).
Liquid damage
Problem
Cause/solution
Liquid or other form of
L Disconnect the AC adaptor and telephone line cord from the base
moisture has entered the
handset/base unit.
Vigyázat:
L To avoid permanent damage, do not use a microwave oven to speed up the drying process.
the correct SMS message centre numbers are stored. Confirm that
SMS is turned on (34. oldal).
subscribed to the appropriate service. Contact your service
provider/telephone company.
oldal).
unable to leave a message. Record your own greeting message
again (36. oldal).
your service provider/telephone company, not your telephone.
Change the unit's number of rings setting or contact your service
provider/telephone company (39. oldal).
oldal).
your remote access code, enter the remote access code setting to
check your current code (38. oldal).
unit. Remove the batteries from the handset and leave to dry for at
least 3 days. After the handset/base unit are completely dry,
reconnect the AC adaptor and telephone line cord. Insert the
batteries and charge fully before use. If the unit does not work
properly, contact an authorised service centre.
Useful Information
49
Advertisement
Table of Contents
