AMX TPI-PRO-2 Operation/Reference Manual page 66

Firmware Pages and Descriptions
Protected Setup Page Elements (Cont.)
System Recovery
Reboot
Keyboard Layout
Serial Port Baud Rate
FIG. 44 Protected Setup page-System Recovery confirmation dialog box
Channel Port
Level Port
Channel Code
Number
FIG. 45 Button/slider Function Show example
60
Allows you to either reset the TPI-PRO to factory default settings and/or wipe
out all existing touch panel pages:
• The Reset System Settings button allows a user to wipe out all current
configuration parameters on the TPI-PRO (such as IP Addresses, Device
Number assignments, Passwords, and other presets).
- Pressing this button launches a confirmation dialog box (FIG. 44) which
asks you to confirm your selection.
- This dialog box is configured with a delay timer that does not enable the
YES button for 5 seconds. This delay provides an additional amount of time
for the user to confirm his decision.
• The Remove User Pages button allows you remove all current TPD4 touch
panel pages currently on the TPI-PRO (including the pre-installed AMX Demo
pages).
- Pressing this button launches a Confirmation dialog box (FIG. 44) which
asks you to confirm your selection.
- This dialog box is configured with a delay timer that does not enable the
YES button for 5 seconds. This delay provides an additional amount of time
for the user to confirm their decision.
Pressing this on-screen button causes the TPI-PRO to restart after saving any
changes.
Use the Keyboard Layout UP/DN buttons to select the type of keyboard you
want to use.
Use the Baud Rate UP/DN buttons to alter the baud rate for the front serial port.
The range is from 1200 - 115200.
• Default is 38400.
Channel Code
Number
3,132
Address
Port
Button
2,8 3,50
Address Code
Number
You have a wait time of 5 seconds
before the YES option is enabled.
Channel Port
7,10
Slider
Level Port
4,9
1,8
Channel Code
Number
TPI-PRO Total Presentation Interface - Pro Edition
Channel Code
Number
Address
Port
Address Code
Number