AMX TPI-PRO-2 Operation/Reference Manual page 47

7. Click on the G4 panel name link associated with the target panel. A secondary web browser window
then appears on the screen (FIG. 29).
The G4 Web Control application is sent by the TPI-PRO to the computer that is used
for communication. Once the application is installed, this popup will no longer appear.
This popup will only appear if you are connecting to the target panel using a different
computer.
FIG. 29 Web Control VNC installation and Password entry screens
8. In some cases, you might get a Connection Details dialog box (FIG. 30) requesting a VNC Server
IP address. This is not the IP address of the Master, but the IP address of the target touch panel.
Depending on which method of communication you are using, you can find the IP address in the IP
Address field in the Wired Ethernet - System Connection > IP Settings section. If you do not see
this field continue to step 9.
FIG. 30 Connection Details dialog
9. If you setup a WebControl password on the G4 WebControl page, a G4 Authentication Session
password dialog box appears on the screen within the secondary browser window.
10. Enter the Web Control session password into the Session password field (FIG. 29). This password
was previously entered into the Web Control Password field within the G4 Web Control page on the
TPI-PRO.
11. Click OK to send the password to the TPI-PRO and begin the session. A confirmation message
appears stating "Please wait, Initial screen loading..."
TPI-PRO Total Presentation Interface - Pro Edition
Configuring Communication
IP Address of touch panel
- obtained from IP Settings section of
the System Connection page
41