AMX TPI-PRO-2 Operation/Reference Manual page 45

5. Press the G4 Web Control button to open the G4 Web Control page (FIG. 27).
FIG. 27 G4 Web Control page
6. Press the Enable/Enabled button until it toggles to Enabled (light blue color).
7. The Network Interface Select field is read-only for the TPI-PRO and uses Wired as the default
method of communication to the web.
8. Press the Web Control Password field to open the Web Password keyboard.
9. From the Web Password keyboard, enter a unique alpha-numeric string to be assigned as the G4
Authentication session password associated with VNC web access of this TPI-PRO.
10. Press Done after you are finished assigning the alpha-numeric string for the Web Control password.
11. Press the Web Control Port field to open the Web Port Number keypad.
12. Within the keypad, enter a unique numeric value to be assigned to the port the VNC Web Server is
running on. The default value is 5900.
13. Press Done when you are finished entering the value. The remaining fields within the G4 Web
Control Settings section of this page are read-only and cannot be altered.
14. Press the Up/Down arrows on either sides of the G4 Web Control Timeout field to increase or
decrease the amount of time the panel can remain idle (no cursor movements) before the session is
closed and the user is disconnected.
15. Press the Back button to open the Protected Setup page.
16. Press the on-screen Reboot button to save any changes and restart the TPI-PRO.
Verify your NetLinx Master's IP Address and System Number have been properly
entered into the Master Connection section of the System Connection page.
TPI-PRO Total Presentation Interface - Pro Edition
Wired is used when a direct Ethernet connection is being used for communication to the web.
This is the default setting if either no wireless interface card is detected or if both an Ethernet
and wireless card connection is detected by the panel.
The Wireless option is unavailable within TPI-PRO.
Configuring Communication
39