FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
1139D136AA
1151D032AA
1151D033AA
1139D139AA
1139D234AA
3. Wind the longer length of the Cable 5-3/4 turns
counterclockwise around the Pulley, working from
the front to back side. Then, slip the Cable Holding
Jig onto the Pulley.
4. Fit the Scanner Drive Gear onto the Scanner Motor
Mounting Bracket using one E-ring.
5. Secure the Scanner Motor Mounting Bracket to the
frame using three screws.
6. Insert a wrench into the holes in the Scanner Drive
Gear and the frame to position the Gear.
7. Wind the longer length of the Cable around Pulleys
C and B and then secure it to the frame.
NOTE
Wind the longer length of the Cable around the lower
groove in Pulley B (of the two grooves). Position the
terminal of the Cable as illustrated on the left.
D-28