Minolta EP1054 Service Manual page 13

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
If, however, the surface is contaminated with fingerprints, clean it using the following proce-
dure.
1076D001
1076D002
1076D003
1076D004
1. Place the PC Drum into one half of its container.
2. Gently wipe the residual toner off the surface of the
PC Drum with a dry, Dust-Free Cotton Pad.
A. Rotate the PC Drum so that the area of its surface
on which the line of toner left by the Cleaning
Blade is present is facing straight up. Wipe the sur-
face in one continuous movement from the rear
edge of the PC Drum to the front edge and off the
surface of the PC Drum.
B. Rotate the PC Drum slightly and wipe the newly
exposed surface area with a CLEAN face of the
Dust-Free Cotton Pad. Repeat this procedure until
the entire surface of the PC Drum has been thor-
oughly cleaned.
At this time, always use a CLEAN face of the dry
Dust-Free Cotton Pad until no toner is evident on the
face of the Pad after wiping.
3. Soak a small amount of either ethyl alcohol or iso-
propyl alcohol into a clean, unused Dust-Free Cot-
ton Pad which has been folded over into quarters.
Now, wipe the surface of the PC Drum in one con-
tinuous movement from its rear edge to its front
edge and off its surface one to two times.
Never move the Pad back and forth.
4. Using the SAME face of the Pad, repeat the proce-
dure explained in the latter half of step 3 until the
entire surface of the PC Drum has been wiped.
Always OVERLAP the areas when wiping. Two
complete turns of the PC Drum would be appropri-
ate for cleaning.
D-2