Specifying The Paper Type - Ricoh SP C250DN Operating Instructions Manual

2. Loading Paper
• For prints from the bypass tray or Tray 1, you can select to print according to either the printer
driver settings or the control panel settings with [Bypass Priority] or [Tray1 Priority] under [Paper
Input]. For details about [Bypass Priority] or [Tray1 Priority], see page 83 "Paper Input Menu".
• If [Auto Continue] under system menu is enabled, printing stops temporarily if a paper type/size
error is detected. The printing restarts automatically with the settings made with the control panel
after about ten seconds. However, if the size of paper specified on the control panel and that of the
paper loaded in the paper tray or the paper size specified for the print job do not match when
printing restarts, it may cause a paper jam. For details about [Auto Continue], see page 89
"System Menu".

Specifying the paper type

This section explains how to specify the paper type.
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Paper Input], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Paper Type], and then press the [OK] key.
4. Press the [ ] or [ ] key to select the paper type setting for the desired tray, and then
press the [OK] key.
5. Press the [ ] or [ ] key to select the desired paper type, and then press the [OK] key.
6. Press the [Menu] key to return to the initial screen.
Specifying the standard paper size
This section explains how to specify the standard paper size.
62
CER408