Step 16, Installation Check List; Step 17, Dishwasher Wet Test; Step 18, Replace Access Panel And Toekick - GE ZBD3500 BB Installation Instructions Manual

Step 16
Installation
Check List
Step 17
Dishwasher
Wet Test
Check List
Step 18
Replace Access
Panel And
Toekick
Check to be sure power is OFF.
Open dishwasher door and remove all
foam and cardboard packaging.
Remove literature package with Use &
Care manual.
Read the Use & Care manual to familiarize
yourself with the operation of the dish-
washer.
Add two quarts of water to the bottom of
the dishwasher to lubricate the pump seal.
Remove the protective film, if present,
from the control panel, door and access
panels.
Turn on power supply.
Latch door.
Select normal cycle on push button or
electronic models.
On dial models, turn control dial just
enough to start dishwasher. Be careful not
to turn the dial past the first water fill. On
electric models, push start pad.
Check to be sure that water enters the
dishwasher. This could take up to 4
minutes.
Check for leaks under the dishwasher. If a
leak is found, turn off power supply,
tighten connections and restore power.
Check for leaks around the door. A leak
around the door could be caused by
dishwasher door rubbing or hitting against
adjacent cabinetry. Reposition the dish-
washer if necessary.
• Place the toekick against the bottom of the
dishwasher.
• Place the access panel assembly against the
dishwasher and tighten the attached screws.
• Re-install two original bottom screws loosely.
Adjust the toekick up or down and tighten
screws.
Be sure to leave literature package and
installation instructions with owner.
Installation
CleanSensor Dishwasher
Check to be sure that wiring is secure
under the dishwasher and not pinched or
in contact with door springs or other
components.
Pull lower rack about half way out. Check
to be sure it does not roll back into dish-
washer or further out. If it does, the
dishwasher needs to be leveled.
Turn on water supply.
Check for plumbing leaks. Tighten connec-
tions if necessary.
Turn on the hot water faucet at the sink.
Water temperature at dishwasher must be
between 120° and 150°F.
The dishwasher will drain for about 5
minutes after the first fill. Check drain
lines. If leaks are found, turn off power,
correct as necessary and restore power.
Open dishwasher door and make sure
most of the water has drained. If not,
check that disposer plug has been removed
and/or air gap is not plugged.
Let the dishwasher run through another
fill and drain cycle. Check again to be sure
there are no leaks.
At the end of the second drain, push the
reset pad on electronic models. On dial
models, unlatch the door and rotate the
dial to the "OFF" position.
Tighten 2
Access Panel Screws
A cc es s Pa ne l
T o e k ic k
Attachment Screws
16