Installation; Step 1, Check Door Balance; Step 2, Remove Wood Base; Step 3, Loosen Leveling Legs - GE ZBD3500 BB Installation Instructions Manual

Step 1
Check
Door Balance
• Unlatch door and remove all foam and
• Check balance by opening and closing door.
Note: Spring hook must be turned to the outside.
• Remove the 4 hex-head screws holding the
Step 2
Remove
Wood Base
• Locate and remove the yellow tape holding
Move the dishwasher close to the installation
Step 3
location and lay on its back.
Loosen
• Loosen the 4 leveling legs with an adjust-
leveling legs
CAUTION
Do not remove wood base until you are
ready to install the dishwasher. The dish-
washer will tip over when the door is
opened.
cardboard packaging.
If necessary, close latch and adjust one or
both springs before the wood base is re-
moved.
dishwasher to the wood base inside the "U"
frame. Discard screws and base.
2 Phillips to the top or side of the dish-
washer. These screws are for securing the
dishwasher to the countertop. Set aside for
later installation.
able wrench and unscrew approximately
3/4".

Installation

CleanSensor Dishwasher
Move spring hook back to
increase tension.
Remove and discard
3/8" Hex Head Screws
Caution: Do not attempt to remove the wood base by prying off
or "kicking". This will cause damage to the dishwasher base.
Approx
. 3/4"
11