Table of Contents
Advertisement
STEP 16 DISHWASHER WET TEST
Turn on power supply (or plug power cord into
outlet, if equipped).
Turn dial to Normal "Wash" position.
Close door.
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to
be sure that water and power are turned on.
Check for leaks under the dishwasher. If a leak
is found, turn power supply off, then tighten
connections. Restore power after leak is corrected.
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the
dishwasher if necessary. See Step 9.
The dishwasher will drain and turn off about 5 to 7
minutes after the first fill. Check drain lines. If leaks
are found, turn power off at the breaker and correct
plumbing as necessary. Restore power after
corrections are made. See Step 12.
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 12. Also check drain line for kinking.
Run the dishwasher through another fill and drain
cycle. Check for leaks and correct if required.
At the end of drain, open door and turn dial to
OFF position.
Installation Instructions
STEP 17 REPLACE TOEKICK
Use Additional 2 Screws
for Installations Over 33-1/2" High
Figure DD
• Place 2-piece toekick against the legs of the
dishwasher.
• Place the inner toekick piece (with slots) against
the toekick bracket. The slots should align with
toekick bracket screw holes. Allow the toekick
to touch the floor.
• Place larger toekick over the inner piece and
install 4 toekick screws.
• Use additional 2 screws for installations over
33-1/2" high.
• Use both toekick pieces for all installation heights.
STEP 18 LITERATURE
Be sure to leave complete literature package and
installation instructions with consumer.
15
Use Top 4
Screw Holes
2 - P ie c e T o e
k ic k
Adjust Up
or Down
Advertisement
Table of Contents
