Step 10, Slide Dishwasher Into Cabinet; Step 11, Level Dishwasher, Align Connections; Step 12, Position Dishwasher And Fasten To Cabinet; Step 13, Connect Water Supply - GE ZBD3500 BB Installation Instructions Manual

Step 10
Slide Dishwasher
Into Cabinet
Step 11
Level Dishwasher,
Align
Connections
Step 12
Position
dishwasher
and fasten
to cabinet
Step 13
Connect
water supply
CAUTION
DO NOT PUSH AGAINST
FRONT DOOR PANEL
WITH KNEES. Damage to
the door panel will occur.
• Level the dishwasher by adjusting the four
leveling legs individually for correct align-
ment.
• Dishwasher should be level, left to right and
front to back for best performance.
• Route the water and electrical supply within
reach of their connection locations under
the dishwasher. Avoid contact with springs
or other components.
• Open the door and position the dishwasher
tub flange 3/4" from the cabinet opening.
• Fasten the dishwasher to the underside of
the countertop, using the 2 Phillips screws
provided. Be sure screws are driven straight
and flush to avoid interference with door
operation.
Important: The dishwasher must be centered in the opening and
have no interference when opening or closing the door.
Interference may cause a water leak or make noise when opening
and closing the door.
• Connect water supply line to 90° elbow
previously installed.
• Open and close the door to insure that door
springs do not come in contact with water
line.
Installation
CleanSensor Dishwasher
• Slide dishwasher into the opening a few
inches a time. As you proceed, pull the drain
hose through the opening and under the
sink.
• Make sure drain hose is not kinked under
the dishwasher.
• Check to be sure there is no interference
with water line and wiring.
Electric
90° Elbow
Rear View
Water
3/4"
Fill Hose
Door Spring
Hot Water
Supply
14