Step 15 Connect Power Supply; Step 16 Pre-Test Check List - GE ZBD6800K Installation Instructions Manual

STEP 15
CONNECT POWER SUPPLY
Skip this step if equipped with power cord.
Go to step 16.
Verify that power is turned off at the source.
• Remove junction box cover "A".
• Secure house wiring to the back of the junction box
with a strain relief "B".
• Locate the three dishwasher wires, (white, black
and green) with stripped ends. Insert dishwasher
wires through the small hole in the junction box "C".
Use wire nuts to connect incoming ground to green,
white to white and black to black "D".
• Replace junction box cover "E". Check to be sure
that wires are not pinched under the cover.
B
A
Insert Power
Remove
Cord Wires Thru
Junction Box
Strain Relief
Cover
and Tighten
Ground
C Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
E Replace Junction Box Cover
WARNING
If house wiring is not 2-wire with ground,
a ground must be provided by the
installer. When house wiring is aluminum,
be sure to use UL Listed anti-oxidant
compound and aluminum-to-copper
connectors.
ATTENTION
Si le circuit de la maison n'est pas un
circuit à deux fils plus fil de terre,
l'installateur doit installer un fil de terre.
Quand le circuit de la maison est en
aluminium, il faut prendre soin d'utiliser
une pâte antioxydante et des connecteurs aluminium
à cuivre sur la liste UL.
Installation Instructions
White
Black
D
Use UL Listed
Wire Nuts
Figure GG
STEP 16
PRE-TEST CHECK LIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your warranty.
Check to be sure power is OFF.
Open door and remove all foam and paper
packaging.
Locate the Owner's Manual in the literature
package.
Read the Owner's Manual for operating instructions.
Check door opening and closing. If door does not
open and close freely or tends to fall, check spring
cable routing and spring adjustments. See Step 1.
Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Steps 8 and 10.
Check door alignment with tub. If door hits tub,
level dishwasher. See Step 11.
Pull lower rack out, about half way. Check to be
sure it does not roll back or forward on the door.
If the rack moves, adjust leveling legs. See Step 11.
Check door alignment with cabinet. If door hits
cabinet, reposition or relevel dishwasher. See
Steps 10, 11 and 12.
Check that door spring does not contact water line,
fill hose, wiring or other components. See Step 13.
Verify water supply and drain lines are not kinked
or in contact with other components. Contact with
motor or dishwasher frame could cause noise.
See Steps 6 and 8.
Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must
be between 120°F and 150°F. A minimum of 120°F
temperature is required for best wash performance.
See "Prepare Hot Water Line," page 7.
Add 2 quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
Turn on water supply. Check for leaks. Tighten
connections if needed.
Remove protective film if present from the control
panel and door.
13