Removing Your Child - KIDDY World Plus Instruction Manual

Check that the protection shield is snuggly and properly adjusted (Fig. 27).
- Make sure the protection shield buckle is locked in place.
- The protection shield is contacting your child and there is no gap
between the protection shield and your child's torso.
- A snuggly adjusted LATCH lower anchor belt should not allow any slack.
The LATCH belt should lie in a relatively straight line and be flat, without
sagging or twist. The protection shield should contact the child but not
press on the child's flesh or push the child's body into an unnatural
position.

Removing your child:

Open the protection shield by releasing the protection shield buckle, rotate
the protection shield across the front of the car seat
protection shield on the vehicle seat beside the car seat.
Remove your child.
To remove car seat from the vehicle:
Press adjustment bar and loosen top tether
belt.
Unhook tether hook by pressing up on flat
spring (Fig. 28; No. 1) and sliding tether
hook off tether anchor (Fig. 28; No. 2).
Fig. 28
While pressing red release button on
LATCH connector (Fig. 29; No. 1) pull
connector out and off LATCH anchor
(Fig. 29; No. 2).
NOTE; Placing knee in car seat and press
Fig. 29
down
connector easier.
22
will make release
and place the
of LATCH