PassFinder AP2520 VoIP Router/Gateway Operation Manual
setting, they cannot check the operation type.
administrators/users can use this command (operation) and add description of
the operation method to the router setup file. After this operation, the router
administrator can check the operation status of the E&M voice port using the
router setup file checking command.
For hardware jumper setting, refer to "Jumper Setting of E&M Module" of
"5.4.2.2 Setting E&M Port."
5.7.3.6.5.
Examples
The following example specifies that an E&M port uses a 2-wire cabling
scheme:
voice-port 1/1
operation 2-wire
5.7.3.7.
output gain
To configure a specific output gain value, use the output gain voice-port
configuration command. Use the no form of this command to disable the
selected output gain value.
output gain value
no output gain value
5.7.3.7.1.
Syntax
Keyword / Argument
value
5.7.3.7.2.
Default Value
0
AddPac Technology Co., Ltd.
Description
The amount of gain in decibels at the transmit side
of the interface.
Acceptable value is any integer from -31 to 31.
The default value for FXO, FXS, and E&M ports is 0..
Version 1.10 / Mar. 2002
To solve this problem,
249
-
-