Adjusting The Optional Blower Speed; Normal Operating Sounds; Normal Operating Odors - Travis Industries 864TRV Owner's Manual

54

Adjusting the Optional Blower Speed

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for
instructions on adjusting the blower speed.
Turn the dial all the
way counter-clockwise
until it clicks off.

Normal Operating Sounds

Blower Snap Disk
This part can produce a
clicking sound as it turns
the blower on and off.
Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these
areas may burn and create an odor. This is normal during start-up. You may notice the smell is
more acute if the appliance was left idle for a long period.
© Travis Industries
Operation
OFF
The high position is all the
way counter-clockwise,
without clicking off.
HIGH
The appliance may creak with change of
temperature -- THIS IS NORMAL.
4050207
LOW
Turn the dial all the
way clockwise.
Blowers
This heater has optional blowers to pus
heated air into the room. You will hear
sound of air movement that increases a
the speed is increased.
Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
Pilot Flame
The pilot flame, which remains on,
makes a very slight "whisper" sound.
100-01168