Wall Switch - Travis Industries 864TRV Owner's Manual

66 Optional Equipment
4 Install the firebacks following the directions below.
Remove the screws and
a
clips on both sides.
Place the floor
firebacks in place.
5 Restore the fireplace to the correct configuration.
Wall Switch Installation
Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The switch must
be installed by a qualified installer.
1. Attach the included wire to the gas control valve.
2. Determine a location for the wall switch (the wire is a maximum 25' long). Route the wire through
the gas inlet hole (either side) to the junction box and attach following the directions below. Set
the on/off switch on the appliance to "OFF" to control the appliance with the wall switch.
Insert the wire
a
through the back of
the mounted
junction box (your
junction box may
look different).
Expose 1/2" of
each wire. Secure
the wires to the
posts on the side of
the on/off switch
(orientation does
not matter).
© Travis Industries
d
Attach the two reciever wires to the
top and bottom posts on the gas
control valve (orientation does not
matter).
From
Appliance
Standard
Screwdriver
(for qualified installers only)
Place the rear fireback in in place. The
b
side fireback holds the rear fireback in
place - hold the rear fireback while
installing the side fireback.
Carefully pack the wires into the
b
junction box. Attach the switch
to the junction box. Attach the
switchplate to the switch.
Standard
Screwdriver
4050207
Place the side firebacks
c
in place. Secure using
the screws and clips
removed in step "a".
100-01168