Operation - Travis Industries 864TRV Owner's Manual

50
ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
Contact your dealer if uncertain your facing has been properly neutralized.
8. Turn the flame adjust knob to its highest position - the flames should be approximately 10" tall.
Check the flame on low position. The flames should burn off of each burner hole. If the heater
does not work correctly, contact your dealer for a remedy.
9. Give this manual to the home owner and fully explain the operation of this heater.
© Travis Industries
Finalizing the Installation
4050207 100-01168