Matrix A7xi Owner's Manual page 5

ADD-ON PCTV (3X AND 5X)
A 15 A or 20 A "Dedicated Circuit" with a non-looped (isolated) neutral/ground is required. Each PCTV requires at least
1.2 A of current. No more than 12 PCTVs should be used for each 15 A circuit and no more than 16 PCTVs should be
used for each 20 A circuit. The power outlet should have the same configuration as the plug. No adapter should be used
with this product. An RG6 coaxial cable with 'F Type' compression fittings will need to be connected between the video
source and each add-on PCTV unit.
ADD-ON DIGITAL TV (3X AND 5X)
Additional power requirements are not needed for the add-on digital TV. An RG6 coaxial cable with 'F Type' compression
fittings will need to be connected between the video source and each add-on digital TV unit.
DANGER
Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a
qualified electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify
the plug provided with the product. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.
WARNING
Connect this exercise product to a properly grounded outlet only.
Never operate product with a damaged cord or plug even if it is working properly. Never operate any product if it
appears damaged, or has been immersed in water. Contact Customer Tech Support for replacement or repair.
WARNING:
Failure to follow these specifications can cause damage to your product and can
void the warranty.
• All video and power outlets must be functional the day of delivery / assembly of the product. The client is responsible
for any additional installation charges associated with return visits.
• Electrical supply may fluctuate in your area. To ensure stable performance of the product, use the proper gauge wire.
8
MX14_AEALB3x_5x_7xe_7xi_OM_Rev1_1.indd 8-9
ELLIPTICAL & ASCENT ASSEMBLY
WARNING
There are several areas during the assembly process that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make sure
all parts are firmly tightened. If the assembly instructions are not followed correctly,
the unit could have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the unit, the assembly instructions must be
reviewed and corrective actions should be taken.
Before proceeding, find the unit's frame serial number located on the stabilizer bar
as shown in the illustration and enter it in the space provided below. The console
serial number is located on a barcode sticker on the console, near the connection
between the console and the mast.
ENTER YOUR SERIAL NUMBERS AND MODEL NAME IN THE BOXES BELOW:
FRAME SERIAL NUMBER:
CONSOLE SERIAL NUMBER:
MODEL NAME:
MATRIX
» Use the information above for initial setup and when calling for service.
FRAME SERIAL NUMBER LOCATION
CONSOLE SERIAL NUMBER LOCATION
9
6/4/14 11:24 AM