Important Safeguards - avertX HIGH DEFINITION NETWORK DOME CAMERA User Manual

IMPORTANT SAFEGUARDS

1. Read Instructions
Read all of the safety and operating instructions before using
the product.
2. Retain Instructions
Save these instructions for future reference.
3. Attachments / Accessories
Do not use attachments or accessories unless recommended
by the appliance manufacturer as they may cause hazards,
damage product and void warranty.
4. Installation
Do not place or mount this product in or on an unstable or
improperly supported location. Improperly installed product
may fall, causing serious injury to a child or adult, and damage
to the product. Use only with a mounting device recommended
by the manufacturer, or sold with the product. To insure proper
mounting, follow the manufacturer's instructions and use only
mounting accessories recommended by manufacturer.
5. Power source
This product should be operated only from the type of power
source indicated on the marking label.
Precautions
Operating
•
Before using, make sure power supply and others are properly
connected.
•
While operating, if any abnormal condition or malfunction is
observed, stop using the camera immediately and then contact
your local dealer.
Handling
•
Do not disassemble or tamper with parts inside the camera.
•
Do not drop or subject the camera to shock and vibration as
this can damage camera.
•
Do not block the cooling holes on the bracket. This camera
has a cooling fan inside the housing. Blocking the cooling
holes will cause heat to build up and cause malfunction.
•
Care must be taken when you clean the clear dome cover.
Scratches and dust will ruin the image quality of your camera.
Do not use strong or abrasive detergents when cleaning the
camera body. Use a dry cloth to clean the camera when it is
dirty. In case the dirt is hard to remove, use a mild detergent
and wipe the camera gently.
Installation and Storage
•
Do not install the camera in areas of extreme temperatures in
excess of the allowable range. (14°F~ 122°F / -10°C ~ 50°C)
•
Avoid installing in humid or dusty places. The relative humidity
must be below 90%.
•
Avoid installing in places where radiation is present.
•
Avoid installing in places where there are strong magnetic
fields and electric signals.
•
Avoid installing in places where the camera would be subject
to strong vibrations.
•
Never face the camera toward the sun. Do not aim at bright
objects. Whether the camera is in use or not, never aim it at
the sun or other extremely bright objects. Otherwise the
camera may be smeared and damaged.