Memory Scan - Icom IC-V82 Instruction Manual

NOTE: Scan edges, 1A–3A/1b–3b, must be programmed
in advance. Program them in the same manner as regular
memory channels. (p. 22)
If identical frequencies are programmed into the scan
edges, programmed scan will not proceed.
A
FUNC
1
TONE
4
DUP
7
PRIO
MONI PWR
B C D
CALL MR CLR
2 3
P.BEEP T.SCAN BANK
5 6 0
SCAN SKIP OPT
8 9
SET H/M/L ENT

■ Memory scan

Memory scan repeatedly scans all programmed memory
channels, except those set as skip channels.
q Push [C•
] to select memory mode, if necessary.
MR
• " X " appears.
• See below to select bank scan.
w Push [A•
] and [5•
FUNC SCAN
• To change the scan direction, push [Y Y ] or [Z Z ].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change
the scan direction. (pgs. 14, 65)
5
A
Push
FUNC
SCAN
e Push [D•
] to stop the scan.
CLR
• Bank scan —Select the desired bank in step q above.
q Push [A•
] and [#•
FUNC BANK
w Rotate [VOL] to select the desired bank, A to J.
e Push [✱•
] (or [D•
ENT CLR
SCAN OPERATION
] to start the scan.
] to select memory bank mode.
]) to select the bank.
8
8
31